Corporate ORphan
Recycles dryer sheets
- Joined
- Sep 21, 2010
- Messages
- 250
Anyone know anything about shifters on a bike? DH's won't go on the largest sprocket and the bike shop wants to replace it instead of repairing it. Below is what he asked me to post on a bike forum which promptly told us to go buy new components. We figure the answers were by the same kind of kids who worked in the bike shop and who always just want the latest and greatest.
Thanks!
"I have a Shimano XTR component set on my mountain bike and I've been having some trouble getting the chain up on to the largest ring on the front sprocket of my bike (the crankset?). The crank sprocket contains three rings (I hope that's the correct terminology) and the derailleur can shift between the lower two rings just fine, but it just won't go out to the largest ring. I thought perhaps that the stops (terminology?) needed adjusting or the cable needed tightening, so I fiddled around with those and it never got any better. I gave up and took it into a local bike shop and they told me that may cable and stops were adjusted just finfe, but the shifter on my left handlebar (which controls the front derailleur) was shot. It just doesn't want to push the derailleur out to that final ring.
They then informed me that there is no hope in fixing it and that I needed to replace it because the shifer contains too many delicate parts (like a watch) and I couldn't get parts for it anyway because my components are so old (we purchased the bike, brand new in the late 90s). They then went on to explain that I would not be able to just purchase and replace that one shifter. They claimed that I need to replace the entire component set because I have a 9 ring rear cassette which is no longer supported in the XTR line, so I need to get new shifters, derailleurs, crank, cassette and brakes (the brake levers are built into the same module as the shifter).
When I balked at the four digit price tag they were dangling in front of me, they recommended I could replace the lever with an XT version and not have to replace any of the other gear. Does any of this make sense?"
Thanks!
"I have a Shimano XTR component set on my mountain bike and I've been having some trouble getting the chain up on to the largest ring on the front sprocket of my bike (the crankset?). The crank sprocket contains three rings (I hope that's the correct terminology) and the derailleur can shift between the lower two rings just fine, but it just won't go out to the largest ring. I thought perhaps that the stops (terminology?) needed adjusting or the cable needed tightening, so I fiddled around with those and it never got any better. I gave up and took it into a local bike shop and they told me that may cable and stops were adjusted just finfe, but the shifter on my left handlebar (which controls the front derailleur) was shot. It just doesn't want to push the derailleur out to that final ring.
They then informed me that there is no hope in fixing it and that I needed to replace it because the shifer contains too many delicate parts (like a watch) and I couldn't get parts for it anyway because my components are so old (we purchased the bike, brand new in the late 90s). They then went on to explain that I would not be able to just purchase and replace that one shifter. They claimed that I need to replace the entire component set because I have a 9 ring rear cassette which is no longer supported in the XTR line, so I need to get new shifters, derailleurs, crank, cassette and brakes (the brake levers are built into the same module as the shifter).
When I balked at the four digit price tag they were dangling in front of me, they recommended I could replace the lever with an XT version and not have to replace any of the other gear. Does any of this make sense?"