TromboneAl
Give me a museum and I'll fill it. (Picasso) Give me a forum ...
- Joined
- Jun 30, 2006
- Messages
- 12,880
Today I used this miter box, which I acquired at a garage sale:
I find that it doesn't cut completely square. The adjustable part is fine, but the vertical cut is off a bit.
I can't find anything that is off square, and the posts are seated properly. That is, if I put the square next to the red box part, it is 90 degrees in relation to the bed.
There doesn't seem to be any way to adjust this left/right tilt.
I'll toss this and go back to using my plastic "box" type unless someone has an idea of how to fix it.
Thanks.
I find that it doesn't cut completely square. The adjustable part is fine, but the vertical cut is off a bit.
I can't find anything that is off square, and the posts are seated properly. That is, if I put the square next to the red box part, it is 90 degrees in relation to the bed.
There doesn't seem to be any way to adjust this left/right tilt.
I'll toss this and go back to using my plastic "box" type unless someone has an idea of how to fix it.
Thanks.